Related Questions
What is the correct answer?
4
Your router is running RIP and OSPF and both routing protocols are learning 192.168.1.0/24. Which routing protocol will your router use for this route?
What is the correct answer?
4
When using debug with PAP, which of the following message types might you see?
What is the correct answer?
4
To recall a previous command, which of the following would you use?
What is the correct answer?
4
Which of the following is a private address?
What is the correct answer?
4
You have this binary value: 11000001. This equates to _____ in decimal.
What is the correct answer?
4
You are given a Class C network with a subnet mask of 255.255.255.248. How many host addresses are there on each subnet?
What is the correct answer?
4
A ___________ is basically all of the components, hardware and software, involved
in connecting computers across small and large distances.
What is the correct answer?
4
Which types of memory do not maintain their contents during a power-off state?
What is the correct answer?
4
When choosing a networking product, you should consider all of the following except _______.
A. Ease of installation and support
B. Product features and functions
What is the correct answer?
4
When using the show interfaces command, which Frame Relay information can you not see?
A. The DLCI number used for LMI
B. The number of LMIs sent and received
What is the correct answer?
4
Which of the following is the most expensive type of WAN connection?
A. Dedicated circuit connection
B. Circuit-switched connection
C. Packet-switched connection
What is the correct answer?
4
The default encapsulation on a synchronous serial interface is _________.
What is the correct answer?
4
A _________ connects two or more LANs in the same geographic area.
What is the correct answer?
4
You are given a Class C network with 25 bits of networking. How many subnets do you have?
What is the correct answer?
4
What command creates a DHCP address pool on a router?
What is the correct answer?
4
The _________ command takes you from User EXEC mode to Privilege EXEC mode
What is the correct answer?
4
BPDU stands for ____________.
A. Bridge Protocol Description Unicast
B. Bridge Protocol Data Unit
C. Bridge Protocol Description Unit
D. Bridge Protocol Data Unicast
What is the correct answer?
4
Which is an example of a hybrid protocol?
What is the correct answer?
4
Which command assigns a default gateway to the 2950 switch?
A. (config)# default-gateway
B. (config-if)# default-gateway
C. (config-if)# ip default-gateway
D. (config)# ip default-gateway
What is the correct answer?
4
_________ negotiates the data link and network layer protocols that will traverse a PPP connection.
What is the correct answer?
4
Which router command creates a standard named ACL called test?
C. ip access-list standard test
D. access-list standard test
What is the correct answer?
4
Which command defines interesting traffic?
What is the correct answer?
4
Which type of routing protocol uses the Shortest Path First algorithm?
What is the correct answer?
4
Which of the following is true concerning full-duplexing?
A. It can either send or receive frames, but not both simultaneously.
B. It can be used with hubs.
C. It can be used with 10Base5 cabling.
D. It uses point-to-point connections.
What is the correct answer?
4
Which of the following is a valid subnet mask value?
What is the correct answer?
4
A _________ uses Gigabit Ethernet as a media type
What is the correct answer?
4
A ________ topology describes how devices communicate with each other.
What is the correct answer?
4
You are given a Class C network, 192.168.1.0/24. You need one network with 120 hosts
and two networks with 60 hosts. How many subnet masks do you need?
What is the correct answer?
4
What would you use to prevent a packet from traveling around a routing loop forever?
What is the correct answer?
4
_________ allows you to create this summarization: 10.0.0.0/7.