Home

The slot number of a 1900's Fast Ethernet uplink ports is ________.

A. 0

B. 1

C. 2

D. No slot number is used

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. Which of the following is true concerning ISL?
  2. Which of the following is a valid subnet mask value?
  3. Which 2950 command enables trunking?
  4. The _________ reference point defines the connection between the NT2 and the NT1.
  5. Which control sequence moves the cursor to the end of the line?
  6. What would you enter to see the last few commands you entered?
  7. Which interface type is used to connect to the serial interface of a router?
  8. If the 1900's mode is FDUP, and the LED is _________, the port speed is set to autodetect.
  9. The dialer map command contains all of the following parameters except __________.
  10. Which of the following is false concerning OSPF?
  11. A ________ topology describes how devices communicate with each other.
  12. Extended IP ACLs should be placed as close to the ____________ device as possible.
  13. You have ISL trunks in your network and five VLANs configured. How many instances of STP are running?
  14. Which would you use to move your cursor back one word?
  15. Which is an example of a hybrid protocol?
  16. A Class A address has _________ host bits.
  17. Frames sent above the __________ limit will have their _________ bit set.
  18. Which of the following is true concerning bridges?
  19. If the 1900 SYSTEM LED is _________, a system POST test has failed.
  20. A __________ route is the best path to reach a destination within the topology table.
  21. Which of the following situations are best for DDR connections?
  22. Which Frame Relay command is used to manually resolve addresses?
  23. _________ describe(s) users working from home.
  24. You are given this address space: 172.16.5.0/25. You need one network with 64 hosts and two with 30…
  25. Which of the following is the most expensive type of WAN connection?
  26. With a rollover cable, pin 7 on one end is mapped to pin ________ on the other end.
  27. Which of the following is true concerning RIPv2?
  28. RIP has a hold-down period of ____________ seconds.
  29. A _________ uses Gigabit Ethernet as a media type
  30. You are given a class C network, 192.168.1.0/24. You need one network with 120 hosts and three networks…