Home

In offset sections, offsets or bends in the cutting plane are all:

Share latest video status. Download from playstore now!

A. 90 degrees

B. 180 degrees

C. Either 90 or 180 degrees

D. 30, 60 or 90 degrees

Share this question with your friends

Correct Answer : A.


Download Objective type questions of Engineering Drawing PDF

Get all objective type questions of Engineering Drawing MCQ

Related Questions

  1. An oil refinery relies on which type of drafter to maintain and update the technical piping drawings…
  2. This type of drawing shows two lines representing the pipe diameter:
  3. This type of solid has two bases that are parallel equal polygons:
  4. This is the total amount that the feature on the actual part is allowed to vary from what is specified…
  5. The section view drawing in which one fourth of an object has been marked for removal is known as a…
  6. Using this as a communication and design review tool can help shorten the process and eliminate productivity…
  7. This is the intersection of the ground plane with the picture plane:
  8. This is the most common application for developments and intersections:
  9. Drafters should use a ________ in a section view of a mechanical part that includes the cylindrical…
  10. In some circumstances an entire drawing can be inserted into a different drawing as a block. When this…
  11. This type of solid is egg-shaped and can be created by revolving an ellipse around one of its axes:
  12. In oblique projection, important shapes should be in this position relative to the viewing plane:
  13. Most architectural drawings produced for field use by building contractors are printed on architectural…
  14. In these drawings it is necessary to show cut surfaces and distinguish between adjacent parts:
  15. Lines of an isometric drawing that are not parallel to the isometric axes are called this:
  16. Placement of dimensions on a drawing is controlled by ________.
  17. The title block used on working drawings should include the __________.
  18. This is the measured size of a finished part:
  19. When dimensioning piping drawings, you give the lengths of all runs of this type:
  20. Some of the common terms used to describe technical drawing include:
  21. Approximately this much of the cost of product development and manufacture is determined at the design…
  22. This type of solid has a polygon for a base and triangular lateral faces that intersect at a vertex:
  23. Architectural dimensioning is usually done in ________.
  24. If a plane is parallel to the plane of projection, it appears:
  25. An accurate record of changes made to release drawings is tracked via this:
  26. Once a drawing is determined to be complete, the title block is used to document the change from:
  27. In this type of dimensioning, allowance must be made for bends:
  28. This is formed where three or more surfaces intersect:
  29. In oblique sketches, the most commonly used angles for receding lines are:
  30. This type of projection is when projectors are parallel to each other, but is at an angle other than…

Please do not use chat terms. Example: avoid using "grt" instead of "great".

Submit
Load More..

Also checkout these categories

Surface Area MCQ Clock MCQ Problems on Numbers MCQ Phylum - Aschelminthes MCQ Radiologic Examination MCQ Transmission of Heat MCQ Endocrine System MCQ Tumors of the prostate MCQ Microsoft Access MCQ Simplification MCQ WAN MCQ Biological Classification MCQ