Home

When using the descriptive geometry method to create an auxiliary view the drafter should __________.

A. Rotate the snap grid to the same angle of the inclined plane

B. Offset the right vertical line of the front view

C. Rotate the top line of the front view 45 degrees

D. Offset the top line of the front view 2 inches

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. Angles project true size only when the plane containing the angle and plane of projection are this:
  2. One critical issue drafters need to pay close attention to is the ________.
  3. The foundation contractor will work with the following architectural plans.
  4. This is a thin solid line directing attention to a note or dimension and starting with an arrowhead…
  5. When creating a block the drafter needs to pay particular attention to selecting a base point because…
  6. The text height for room names should be set to ________for a drawing that will be plotted to a scale…
  7. The second line of dimensions out from the plan generally includes ________.
  8. Elevation drawings will include information about ________.
  9. On typical electronic diagrams, these items need not be shown unless they are needed for clarification:
  10. The building construction industry relies on sets of ________ drawings to construct homes and commercial…
  11. The Free Orbit tool is found on the ________ toolbar.
  12. This is a rounded exterior blend between surfaces:
  13. The principle views associated with orthographic projection are ________.
  14. A drafter who develops technical drawings of a highway overpass would most likely be a ________ drafter.
  15. Drawings created with commercial software are typically saved as:
  16. Architectural dimensioning standards allow for the placement of dimensions inside the floor plan. These…
  17. These types of pipes are generally connected with bell and spigot joints or flanged joints:
  18. Three dimensional models are often used in the design process to __________.
  19. The ________ is a standard element of a section view in a technical drawing.
  20. These are special installations of stone or concrete marking the locations of points accurately determined…
  21. In an oblique drawing, equally spaced partial circles may be used to show this:
  22. When using the descriptive geometry method to create an auxiliary view the drafter should __________.
  23. Inserting blocks into a drawing file usually requires exacting placement. The drafter should insure…
  24. The ________ tool on the Dimension tool bar will place several dimensions at one time by using a selection…
  25. Which of the following is one of the basic types of welded joints:
  26. When designing a home for a client, one of the most important predesign considerations that an architect…
  27. This type of solid has two bases that are parallel equal polygons:
  28. The architectural and construction industries use the United States National CAD standard (NCS) system…
  29. Before starting an isometric drawing in Auto-CAD the drafter needs to ________.
  30. When creating an isometric drawing in Auto-CAD the drafter can utilize the Dynamic Input and Polar Coordinate…