Related Questions
What is the correct answer?
4
Which type of traffic is sent to a group of devices?
What is the correct answer?
4
If the port status LED on a 2950 is ________, there is a physical layer connection problem.
A. Flashing green and amber
What is the correct answer?
4
RIP supports load balancing for up to __________ ___________ paths.
What is the correct answer?
4
Which router command would you use to view the configuration register value?
What is the correct answer?
4
A __________ route is the best path to reach a destination within the topology table.
What is the correct answer?
4
You are at User EXEC mode and type the letter e. What message appears?
C. % Unknown command or computer name
D. % Invalid input detected at '^'.
What is the correct answer?
4
172.16.240.256 is a class __________ address.
What is the correct answer?
4
What uses 64 Kbps of bandwidth?
What is the correct answer?
4
___________ defines LAPD, which is responsible for the data-link layer connection between the router and the ISDN switch.
What is the correct answer?
4
You are given a class C network, 192.168.1.0/24. You need three networks with 60 hosts and two networks with 30 hosts. What are the subnet mask values you could use?
A. 255.255.255.128 and 255.255.255.192
B. 255.255.255.224 and 255.255.255.240
C. 255.255.255.192 and 255.255.255.224
What is the correct answer?
4
Which of the following is false concerning OSPF?
A. It provides a loop-free topology.
B. It is a classful protocol and allows for a hierarchical design.
C. It requires more memory and processing cycles than distance vector protocols.
D. It is complex to configure and difficult to troubleshoot.
What is the correct answer?
4
You examine your interfaces, and the Ethernet 0 interface status says: Ethernet 0 is up, line protocol is down. What does this indicate?
A. There is a physical layer problem.
B. There is a data link layer problem.
C. There is a network layer problem.
What is the correct answer?
4
EIGRP uses the _________ algorithm to update its routing table.
What is the correct answer?
4
OSPF uses __________ as a metric.
What is the correct answer?
4
Which interface type is used to connect to the serial interface of a router?
What is the correct answer?
4
The router automatically saves its configuration.
What is the correct answer?
4
How would you suspend a telnet session?
What is the correct answer?
4
The address of a Frame Relay VC is called a ___________.
A. Data link layer connection identifier
B. Data layer connection index
C. Data link connection index
D. Data link connection identifier
What is the correct answer?
4
What router command saves the active configuration to NVRAM?
A. copy nvram startup-config
B. copy startup-config running-config
C. copy running-config nvram
D. copy running-config startup-config
What is the correct answer?
4
You execute the line console 0 command from Configuration mode. What will the router's prompt be?
C. Router(config-interface)#
What is the correct answer?
4
__________ states that if a neighboring router sends a route to a router, the receiving router will not propagate this route back to the advertising router on the same interface.
What is the correct answer?
4
Which of the following are not features of ACLs?
A. Restricting telnet access to a router
B. Prioritizing WAN traffic
C. Filtering traffic from the router
D. Triggering dialup phone calls
What is the correct answer?
4
An idle DDR connection will be torn down after _________ seconds of not seeing interesting traffic.
What is the correct answer?
4
You are given a Class C network with a subnet mask of 255.255.255.248. How many host addresses are there on each subnet?
What is the correct answer?
4
Which command assigns a default gateway to the 2950 switch?
A. (config)# default-gateway
B. (config-if)# default-gateway
C. (config-if)# ip default-gateway
D. (config)# ip default-gateway
What is the correct answer?
4
If the 2950's RPS is ________, the external power supply is supplying power.
What is the correct answer?
4
Which control sequence moves the cursor to the end of the line?
What is the correct answer?
4
Which of the following is not true concerning TCP?
A. Provides for reliable connections
B. Uses windowing for flow control
C. Multiplexes applications
D. Is more efficient than UDP
What is the correct answer?
4
Which router command specifies the ISDN switch the router is connected to?
What is the correct answer?
4
A VTP server switch generates a summary advertisement every _________ minutes.