If the 2950's RPS is ________, the external power supply is supplying power.
Off
Amber
Flashing amber
Green
Correct Answer :
C. Flashing amber
Related Questions
When configuring your terminal emulation software for a console connection, set the flow control to __________.
Hardware
Software
None
172.16.240.256 is a class __________ address.
A
B
C
None of the above
Ethernet ___________ has/have both a physical and logical bus topology.
10BaseT
10Base2 and 10Base5
10BaseT and 10Base2
10BaseT, 10Base2, and 10Base5
Which command takes you from Privilege EXEC mode to User EXEC mode?
enable
disable
exit
logout
Which of the following WAN categories does ISDN fall under?
Dedicated circuit connection
Circuit-switched connection
Packet-switched connection
Which router command would take you back to a suspended telnet session?
reconnect
connect
resume
toggle
Which of the following are not features of ACLs?
Restricting telnet access to a router
Prioritizing WAN traffic
Filtering traffic from the router
Triggering dialup phone calls
When backing up your IOS image from flash, which of the following will the copy flash tftp command prompt you for? (Choose all correct answers.)
TFTP server IP address
Verification to copy
Source filename
Destination filename
RIP supports load balancing for up to __________ ___________ paths.
Six, unequal-cost
Four, unequal-cost
Four, equal-cost
Six, equal-cost
If you see a VC with an inactive status, this indicates ____________.
The connection between both Frame Relay DTEs is up and operational.
The connection between your Frame Relay DTE and DCE is up and operational, but there is something wrong with connection between your connected Frame Relay switch and the destination DTE.
You are not receiving any LMI messages from the Frame Relay switch.
Which of the following is stored in ROM? (Choose all correct answers.)
POST
ROMMON
Configuration file
System recovery file
You are given the following addressing information: 172.17.16.255/23. What type of address is this?
Network
Directed Broadcast
Host
Which router command creates a standard named ACL called test?
ip access-list test
access-list test
ip access-list standard test
access-list standard test
You have a 24-channel T1 connection to your router. How many VCs does this T1 support?
1
24
No limit
A Class A address has _________ host bits.
8
16
20
24
You are given a Class B network with a subnet mask of 255.255.255.192. How many host
addresses are there on each subnet?
30
62
126
254
What must you do to enable IP routing on your router? (Choose all of the correct answers.)
Enable the routing protocol.
Set clocking on all serial interfaces.
Assign IP addresses to your router's interfaces.
Assign the bandwidth parameter to your serial interfaces
The _______ program goes out and finds the IOS and loads it.
ROMMON
Bootstrap
Mini-IOS
Loader
You examine your interfaces, and the Ethernet 0 interface status says: Ethernet 0 is up, line protocol is down. What does this indicate?
There is a physical layer problem.
There is a data link layer problem.
There is a network layer problem.
There is no problem.
When choosing a dynamic routing protocol, which of the following should not be considered?
Metrics used
How routing information is shared
How routing information is processed
Number of PCs in the network
PPP can do all of the following except ___________.
Authentication
Compression
Quality of Service
None of these
A __________ topology uses a single connection to connect all devices together.
Bus
Star
Point-to-point
Ring
Which of the following is false concerning OSPF?
It provides a loop-free topology.
It is a classful protocol and allows for a hierarchical design.
It requires more memory and processing cycles than distance vector protocols.
It is complex to configure and difficult to troubleshoot.
What subnet mask would you use to set up a default route?
0.0.0.0
255.255.255.255
Depends on the type of network number
None of these answers
Which 1900 command enables port security?
port security
switchport security
port secure
switchport port-security
You are given a Class C network, 192.168.1.0/24. You need one network with 120 hosts
and two networks with 60 hosts. How many subnet masks do you need?
1
2
3
4
Which is an example of a hybrid protocol?
IGRP
EIGRP
RIPv1
OSPF
You execute the line console 0 command from Configuration mode. What will the router's prompt be?
Router(config)#
Router(config-line)#
Router(config-interface)#
Router#(config-if)
A ________ topology describes how devices communicate with each other.
Physical
Logical
You are given a class C network and you have four LAN segments with the following numbers of devices: 120, 60, and two with 30. What subnet mask values would you use to accommodate these segments?
/24, /25, and /26
/25, /26, and /27
/26, /27, and /28
None of these