Related Questions
What is the correct answer?
4
The 1900 switch supports ________ VLANs.
What is the correct answer?
4
If the 2950's RPS is ________, the external power supply is supplying power.
What is the correct answer?
4
Which router command clears all of the static translations in the address translation table?
A. erase ip nat translation *
B. clear ip nat translation *
C. clear ip nat translation all
D. None of these commands
What is the correct answer?
4
EIGRP generates hellos every _________ seconds on LAN segments.
What is the correct answer?
4
The ___________ is the point where the carrier's responsibility ends and yours begins.
What is the correct answer?
4
Which of the following is a Network layer protocol for the TCP/IP protocol stack?
What is the correct answer?
4
An _____________ is a public IP address associated with an inside device.
A. Inside global IP address
B. Inside local IP address
C. Outside global IP address
D. Outside local IP address
What is the correct answer?
4
If the 1900's mode is FDUP, and the LED is _________, the port speed is set to autodetect.
What is the correct answer?
4
172.16.240.256 is a class __________ address.
What is the correct answer?
4
The ___________ converts an ISDN four-wire connection to a two-wire connection.
What is the correct answer?
4
The root switch is the one elected with the __________ __________.
What is the correct answer?
4
Extended traceroute works from which mode?
D. User and Privilege EXEC
What is the correct answer?
4
A __________ route is the best path to reach a destination within the topology table.
What is the correct answer?
4
Which type of traffic is not flooded?
What is the correct answer?
4
The address of a Frame Relay VC is called a ___________.
A. Data link layer connection identifier
B. Data layer connection index
C. Data link connection index
D. Data link connection identifier
What is the correct answer?
4
A _________ is used to connect networking devices that are in a very close geographic area, such as a floor of a building, a building itself, or a campus environment.
What is the correct answer?
4
A _________ routes between different autonomous systems.
What is the correct answer?
4
OSPF supports a ________-layer hierarchical design.
What is the correct answer?
4
The TCP/IP protocol stack has ________ layers.
What is the correct answer?
4
What router command saves the active configuration to NVRAM?
A. copy nvram startup-config
B. copy startup-config running-config
C. copy running-config nvram
D. copy running-config startup-config
What is the correct answer?
4
Which of the following commands belongs on the physical interface when using dialer profiles?
What is the correct answer?
4
You are given a class C network and you have four LAN segments with the following numbers of devices: 120, 60, and two with 30. What subnet mask values would you use to accommodate these segments?
What is the correct answer?
4
You are in Interface Subconfiguration mode and want to completely return to Privilege EXEC mode. What would you enter? (Choose all correct answers.)
What is the correct answer?
4
If you wanted a list of parameters for the show command, you would type ________.
What is the correct answer?
4
_________ negotiates the data link and network layer protocols that will traverse a PPP connection.
What is the correct answer?
4
What subnet mask would you use to set up a default route?
C. Depends on the type of network number
What is the correct answer?
4
A ___________ is similar to a telephone circuit-switched connection.
What is the correct answer?
4
The OSPF process ID is __________.
A. Locally significant and is the router ID
B. Globally significant and must be configured on every router
D. OSPF doesn't use a process ID, but an AS number
What is the correct answer?
4
A routing protocol that supports route summarization must perform all except which of the following?
A. Carry the subnet mask with the network entry.
B. Make routing decisions based on the entire destination IP address.
C. Summarize entries so that the same lowest-order bits match.
What is the correct answer?
4
Which of the following are not features of ACLs?
A. Restricting telnet access to a router
B. Prioritizing WAN traffic
C. Filtering traffic from the router
D. Triggering dialup phone calls