Related Questions
What is the correct answer?
4
___________ has both physical and logical ring topologies.
What is the correct answer?
4
When connecting a router to a PC, use a __________ cable.
What is the correct answer?
4
When examining the IP routing table, an EIGRP route will be shown as what letter?
What is the correct answer?
4
Which of the following commands belongs on the physical interface when using dialer profiles?
What is the correct answer?
4
Which of the following is true concerning RIPv2?
A. It uses triggered updates.
D. It doesn't support route summarization
What is the correct answer?
4
Which of the following is stored in ROM? (Choose all correct answers.)
What is the correct answer?
4
You are given a Class B network with a subnet mask of 255.255.255.192. How many host
addresses are there on each subnet?
What is the correct answer?
4
Which of the following is a Network layer protocol for the TCP/IP protocol stack?
What is the correct answer?
4
Which interface type is used to connect to the serial interface of a router?
What is the correct answer?
4
An OSPF's router ID is based on __________.
A. The lowest IP address on its loopback interface, if configured, or the lowest IP address onits active interfaces
B. The highest IP address on its loopback interface, if configured, or the highest IP address on its active interfaces
C. The highest IP address on its active interfaces, if configured, or the highest IP address on its loopback interfaces
D. The lowest IP address on its active interfaces, if configured, or the lowest IP address on its loopback interfaces
What is the correct answer?
4
When a carrier experiences congestion, it marks the _______ bit in the header of the Frame Relay frame.
What is the correct answer?
4
Which of the following is the most expensive type of WAN connection?
A. Dedicated circuit connection
B. Circuit-switched connection
C. Packet-switched connection
What is the correct answer?
4
Which is an example of a hybrid protocol?
What is the correct answer?
4
What would you use to prevent a packet from traveling around a routing loop forever?
What is the correct answer?
4
_________ is/are a routed protocol.
What is the correct answer?
4
A __________ topology uses a single connection to connect all devices together.
What is the correct answer?
4
RIP supports load balancing for up to __________ ___________ paths.
What is the correct answer?
4
The router automatically saves its configuration.
What is the correct answer?
4
You have a total of five routers. ________ circuits are required to fully mesh the network, where every router needs ___________ interfaces.
What is the correct answer?
4
Which 2950 command enables trunking?
What is the correct answer?
4
How would you suspend a telnet session?
What is the correct answer?
4
When using debug with PAP, which of the following message types might you see?
What is the correct answer?
4
How many steps do LCP and NCP go through when setting up a connection?
What is the correct answer?
4
Which of the following is true concerning bridges?
A. They switch frames in hardware.
B. They support half- and full-duplexing.
C. They support one collision domain for the entire bridge.
D. They do only store-and-forward switching.
What is the correct answer?
4
If you wanted a list of parameters for the show command, you would type ________.
What is the correct answer?
4
_________ describe(s) users that can connect to a network from any location.
What is the correct answer?
4
Which router command would you use to view the configuration register value?
What is the correct answer?
4
Which Frame Relay command is used to manually resolve addresses?
A. frame-relay interface-dlci
What is the correct answer?
4
When choosing a WAN solution, consider all of the following except __________.
What is the correct answer?
4
With _________ switching, the switch reads the destination MAC address of the frame and
immediately starts forwarding the frame.