Related Questions
What is the correct answer?
4
_________ allows you to create this summarization: 10.0.0.0/7.
What is the correct answer?
4
_________ is/are a routed protocol.
What is the correct answer?
4
Which controller command specifies how ones and zeros are represented on a digital circuit?
What is the correct answer?
4
You are given a Class C network with a subnet mask of 255.255.255.248. How many host addresses are there on each subnet?
What is the correct answer?
4
Your router is running RIP and OSPF and both routing protocols are learning 192.168.1.0/24. Which routing protocol will your router use for this route?
What is the correct answer?
4
A _________ is used to connect networking devices that are in a very close geographic area, such as a floor of a building, a building itself, or a campus environment.
What is the correct answer?
4
BPDU stands for ____________.
A. Bridge Protocol Description Unicast
B. Bridge Protocol Data Unit
C. Bridge Protocol Description Unit
D. Bridge Protocol Data Unicast
What is the correct answer?
4
191.75.39.24 is a Class __________ address.
What is the correct answer?
4
What would you use to prevent a packet from traveling around a routing loop forever?
What is the correct answer?
4
An OSPF's router ID is based on __________.
A. The lowest IP address on its loopback interface, if configured, or the lowest IP address onits active interfaces
B. The highest IP address on its loopback interface, if configured, or the highest IP address on its active interfaces
C. The highest IP address on its active interfaces, if configured, or the highest IP address on its loopback interfaces
D. The lowest IP address on its active interfaces, if configured, or the lowest IP address on its loopback interfaces
What is the correct answer?
4
When configuring the ip nat inside source command, which parameter must you specify to perform PAT?
What is the correct answer?
4
Which of the following are not features of ACLs?
A. Restricting telnet access to a router
B. Prioritizing WAN traffic
C. Filtering traffic from the router
D. Triggering dialup phone calls
What is the correct answer?
4
An _____________ is a public IP address associated with an inside device.
A. Inside global IP address
B. Inside local IP address
C. Outside global IP address
D. Outside local IP address
What is the correct answer?
4
Which frame field is different between ISO HDLC and Cisco's HDLC?
What is the correct answer?
4
Which of the following is the most expensive type of WAN connection?
A. Dedicated circuit connection
B. Circuit-switched connection
C. Packet-switched connection
What is the correct answer?
4
What must you do to enable IP routing on your router? (Choose all of the correct answers.)
A. Enable the routing protocol.
B. Set clocking on all serial interfaces.
C. Assign IP addresses to your router's interfaces.
D. Assign the bandwidth parameter to your serial interfaces
What is the correct answer?
4
Which VTP mode(s) will propagate VTP messages?
C. Client, server, and transparent
What is the correct answer?
4
Which router command would take you back to a suspended telnet session?
What is the correct answer?
4
The _______ program goes out and finds the IOS and loads it.
What is the correct answer?
4
If the 1900 SYSTEM LED is _________, a system POST test has failed.
D. Flashing green and amber
What is the correct answer?
4
Choose the following that a standard IP ACL can match on.
C. IP protocol information
What is the correct answer?
4
The _________ command takes you from User EXEC mode to Privilege EXEC mode
What is the correct answer?
4
Cisco routers generate LMI enquiries every _______ seconds and a full status update every _________ seconds.
What is the correct answer?
4
You examine your interfaces, and the Ethernet 0 interface status says: Ethernet 0 is up, line protocol is down. What does this indicate?
A. There is a physical layer problem.
B. There is a data link layer problem.
C. There is a network layer problem.
What is the correct answer?
4
Extended traceroute works from which mode?
D. User and Privilege EXEC
What is the correct answer?
4
Which of the following is true concerning full-duplexing?
A. It can either send or receive frames, but not both simultaneously.
B. It can be used with hubs.
C. It can be used with 10Base5 cabling.
D. It uses point-to-point connections.
What is the correct answer?
4
A ___________ is similar to a telephone circuit-switched connection.
What is the correct answer?
4
Which of the following is not an advantage of DHCP?
A. It allows for the use of private addressing.
B. It reduces the amount of configuration on devices.
C. It reduces likelihood of configuration errors.
D. It gives you more control by centralizing IP addressing information.
What is the correct answer?
4
You are given a Class C network with 25 bits of networking. How many subnets do you have?
What is the correct answer?
4
Which of the following is a private address?