Home

Which controller command specifies how ones and zeros are represented on a digital circuit?

A. framing

B. linecode

C. clock source

D. interface

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. The 1900 switch supports ________ VLANs.
  2. A _________ uses Gigabit Ethernet as a media type
  3. Which of the following commands belongs on the physical interface when using dialer profiles?
  4. Which of the following reasons might you need to use address translation?
  5. If you wanted a list of parameters for the show command, you would type ________.
  6. When connecting a switch to a router, use a ___________ cable.
  7. Which controller command specifies how ones and zeros are represented on a digital circuit?
  8. A __________ route is the best path to reach a destination within the topology table.
  9. Which types of memory do not maintain their contents during a power-off state?
  10. You are given a Class C network with a subnet mask of 255.255.255.248. How many host addresses are there…
  11. Which of the following are not features of ACLs?
  12. Which of the following is a private address?
  13. You have ISL trunks in your network and five VLANs configured. How many instances of STP are running?
  14. _________ is/are a routed protocol.
  15. Which Frame Relay command is used to manually resolve addresses?
  16. Which router command would take you back to a suspended telnet session?
  17. You execute the line console 0 command from Configuration mode. What will the router's prompt be?
  18. Which router command performs an overwrite process? (Choose all correct answers.)
  19. Extended IP ACLs should be placed as close to the ____________ device as possible.
  20. A _________ routes between different autonomous systems.
  21. A routing protocol will use a _________ to determine which path is the best path.
  22. When configuring the ip nat inside source command, which parameter must you specify to perform PAT?
  23. Which of the following is a Network layer protocol for the TCP/IP protocol stack?
  24. If the 2950's RPS is ________, the external power supply is supplying power.
  25. Which is not one of the three main functions of a layer-2 device?
  26. _________ negotiates the data link and network layer protocols that will traverse a PPP connection.
  27. _________ defines how the Frame Relay DTE and DCE interact with each other.
  28. A routing protocol that supports route summarization must perform all except which of the following?
  29. OSPF hellos are sent every __________ seconds on a multi-access medium.
  30. Which of the following is true concerning full-duplexing?