Related Questions
What is the correct answer?
4
Bearing capacity of soils cannot be improved by
A. Draining sub-soil water
B. Ramming crushed stone in soil
D. Watering surface of soil
What is the correct answer?
4
The dimensions of a half queen closer, are
D. 1.8 cm × 4.5 cm × 9 cm
What is the correct answer?
4
Couple roof is used for spans
B. 3.5 m but less than 5 m
C. 5 m but less than 6.5 m
D. 6.5 m but less than 8 m
What is the correct answer?
4
The position of a brick when laid on its side 9 cm × 9 cm with its frog in the vertical plane, is called
What is the correct answer?
4
A covering of concrete placed on the exposed top of an external wall, is known as
What is the correct answer?
4
The form work from the sides of beams can be removed only after
What is the correct answer?
4
The type of arch used for high class buildings where appearance is of prime importance, is known as
What is the correct answer?
4
The radial splits which are wider on the outside of the log and narrower towards the pith are known as
What is the correct answer?
4
A roof which slopes in four directions, is called
What is the correct answer?
4
The term string is used for
A. The underside of a stair
B. Outer projecting edge of a tread
C. A sloping member which supports the steps in a stair
D. A vertical member between two treads
What is the correct answer?
4
The method of moving each brick through a small horizontal distance before it is finally laid in any brick wall and pressing it by means of brick hammer, is known as
What is the correct answer?
4
To obtain good bonding in brick masonry
A. First class bricks are used
B. Vertical joints in alternate courses are kept in plumb line
C. Bats are used where necessary
What is the correct answer?
4
The concrete slump recommended for beams and slabs; is
What is the correct answer?
4
Pile foundations are suitable for
D. Multi-storeyed buildings
What is the correct answer?
4
Rotary drilling is the fastest method in case of
What is the correct answer?
4
Exposed portions of vertical surface at right angles to the door or window frame, are known as
What is the correct answer?
4
Pick up the correct statements from the following:
A. Cracks appear on the plastered surface in the form of hair cracks
B. In brick work, the efflorescence is removed by applying a solution of zinc sulphate and water
C. Excessive thermal variations in the backing or plaster causes the plaster to fall
What is the correct answer?
4
Two columns 50 cm × 50 cm and 60 cm × 60 cm carry 80 tonnes and 120 tonnes of loads respectively. The centre to centre distance between columns is 5.00 metres. The permissible bearing capacity of the soil is 20 t/m2. If the footing is not to project more than 25 cm beyond the outside of the smaller column, pick up the correct design parameters of the footing from the following:
A. Distance of C.G. of the loads from the smaller column = 3.00 m
B. The length of the foundation slab = 7.00 m
C. Area of footing slab = 11.00 m2
What is the correct answer?
4
The foundation which consists of a thick reinforced cement slab covering whole area to support heavy concentrated structural loads, is known as
What is the correct answer?
4
The floor is rubbed with oxalic acid, for making its surface
What is the correct answer?
4
The type of roof which slopes in two directions with a break in the slope on each side is known as
What is the correct answer?
4
Gravels
A. Are cohesionless aggregates
B. Vary in size between 2 to 20 mm
C. Never swell when they come into contact with water
What is the correct answer?
4
Cast iron piles
A. Are suitable for works under sea water
B. Resist shocks or vibrations
C. Are suitable for use as batter piles
D. Are useful for heavy vertical loads
What is the correct answer?
4
The highest line of sloping roof, where two opposite slopes meet, is known as
What is the correct answer?
4
Vertical construction joints are provided where the shearing forces are minimum in the case of
What is the correct answer?
4
The vertical posts placed at the top and bottom ends of a flight supporting the hand rail are known as
What is the correct answer?
4
The lower half portion between crown and skew back of the arch, is called
What is the correct answer?
4
The vertical members fixed between steps and hand rail, are known
What is the correct answer?
4
The maximum permissible deflection of a timber beam supporting a roof, is
What is the correct answer?
4
The type of footing which is used to transmit heavy loads through steel columns is