Related Questions
What is the correct answer?
4
When using the show interfaces command, which Frame Relay information can you not see?
A. The DLCI number used for LMI
B. The number of LMIs sent and received
What is the correct answer?
4
Which of the following is true concerning 802.1Q?
A. It supports hub connections.
B. It is supported on both the 1900 and 2950 switches.
C. The native VLAN is tagged.
D. The original Ethernet frame is not modified.
What is the correct answer?
4
A ___________ is basically all of the components, hardware and software, involved
in connecting computers across small and large distances.
What is the correct answer?
4
When configuring the ip nat inside source command, which parameter must you specify to perform PAT?
What is the correct answer?
4
If you wanted a list of parameters for the show command, you would type ________.
What is the correct answer?
4
Which of the following WAN categories does ISDN fall under?
A. Dedicated circuit connection
B. Circuit-switched connection
C. Packet-switched connection
What is the correct answer?
4
Frames sent above the __________ limit will have their _________ bit set.
What is the correct answer?
4
Which of the following is true concerning bridges?
A. They switch frames in hardware.
B. They support half- and full-duplexing.
C. They support one collision domain for the entire bridge.
D. They do only store-and-forward switching.
What is the correct answer?
4
You have a total of five routers. ________ circuits are required to fully mesh the network, where every router needs ___________ interfaces.
What is the correct answer?
4
A ________ topology describes how devices communicate with each other.
What is the correct answer?
4
A ___________ is similar to a telephone circuit-switched connection.
What is the correct answer?
4
What uses 64 Kbps of bandwidth?
What is the correct answer?
4
Which of the following is true concerning full-duplexing?
A. It can either send or receive frames, but not both simultaneously.
B. It can be used with hubs.
C. It can be used with 10Base5 cabling.
D. It uses point-to-point connections.
What is the correct answer?
4
RIP generates routing updates every _________ seconds.
What is the correct answer?
4
What command creates a DHCP address pool on a router?
What is the correct answer?
4
What router command saves the active configuration to NVRAM?
A. copy nvram startup-config
B. copy startup-config running-config
C. copy running-config nvram
D. copy running-config startup-config
What is the correct answer?
4
With a rollover cable, pin 7 on one end is mapped to pin ________ on the other end.
What is the correct answer?
4
Which of the following are classless protocols?
What is the correct answer?
4
Which of the following is a private address?
What is the correct answer?
4
There are _________ actions a router can take when there is a match on an ACL statement
What is the correct answer?
4
A _________ connects two or more LANs in the same geographic area.
What is the correct answer?
4
You have a 24-channel T1 connection to your router. How many VCs does this T1 support?
What is the correct answer?
4
An idle DDR connection will be torn down after _________ seconds of not seeing interesting traffic.
What is the correct answer?
4
Which of the following are not features of ACLs?
A. Restricting telnet access to a router
B. Prioritizing WAN traffic
C. Filtering traffic from the router
D. Triggering dialup phone calls
What is the correct answer?
4
An OSPF's router ID is based on __________.
A. The lowest IP address on its loopback interface, if configured, or the lowest IP address onits active interfaces
B. The highest IP address on its loopback interface, if configured, or the highest IP address on its active interfaces
C. The highest IP address on its active interfaces, if configured, or the highest IP address on its loopback interfaces
D. The lowest IP address on its active interfaces, if configured, or the lowest IP address on its loopback interfaces
What is the correct answer?
4
The ___________ converts an ISDN four-wire connection to a two-wire connection.
What is the correct answer?
4
Which of the following is true concerning ISL?
A. It is supported on both the 1900 and 2950 switches.
B. It adds a 26-byte trailer and 4-byte header.
C. Tagging is done in software.
D. The original Ethernet frame is not modified.
What is the correct answer?
4
Which of the following is true concerning RIPv2?
A. It uses triggered updates.
D. It doesn't support route summarization
What is the correct answer?
4
_________ is/are a routed protocol.
What is the correct answer?
4
Which type of routing protocol uses the Shortest Path First algorithm?