A circular arc is dimensioned in the view where you see its true shape by giving the value for its:
Diameter
Arc length
Radius
Chord length
Also checkout these categories
General Biology MCQ Chemical Engineering Thermodynamics MCQ Computer Fundamental MCQ Sitting Arrangement MCQ Heat & Mass Transfer MCQ Percentage MCQ Fill in the blanks MCQ Angiosperms (Inflorescence, Flower and Fruit) MCQ Idioms & Phrases MCQ Electro-Chemistry MCQ Rearrangement Set 3 MCQ Python Programming MCQ
- Oblique drawings are dimensioned in a similar fashion as these types of drawings:
- When setting up a mechanical drawing in Auto-CAD the drafter should set the units to ________.
- A ________ section allows the drafter to create a Cutting Plane line which is not in a straight line…
- This is an angled surface used on cylinders to make them easier to handle:
- 4.The principle reason for using an auxiliary view is ________.
- In architectural drawing ________ are often used to illustrate and detail structural components.
- This type of projection is when projectors are parallel to each other, but is at an angle other than…
- A partial auxiliary view is used to show only the ________ in the auxiliary view.
- This is a common method for connecting steel members of buildings and bridges:
- This is a conical-shaped recess around a hole, often used to receive a tapered screw head:
- This process recognizes the inherent interrelationships between design and manufacturing:
- This is used in applications for nonferrous construction:
- A drafter who develops technical drawings of a highway overpass would most likely be a ________ drafter.
- A half-moon protractor is divided into how many degrees?
- An architect often relies on a ________ to complete the set of technical drawings used in the design…
- If designs require changes, they should be documented with:
- Objects that are symmetric can be shown effectively using this type of section:
- This type of rapid prototyping system uses a laser to fuse powdered metals, plastics, or ceramics:
- The top, front, and bottom views align in this manner:
- PDM is the acronym for:
- If a designer is developing a plan for a project in which the entire part is made out of ¾ thick…
- The first step in creating a traditional technical drawing is to ________.
- The architectural and construction industries use the United States National CAD standard (NCS) system…
- These types of pipes are generally connected with bell and spigot joints or flanged joints:
- In the mechanical design process the first step is to ________.
- The typical parts list should include the ________.
- Some traditional board drafters preferred the drafting machine over the parallel straight edge because…
- The text used on a typical detail sheet should be ________.
- This type of drawing shows two lines representing the pipe diameter:
- If a plane is parallel to the plane of projection, it appears: