Related Questions
What is the correct answer?
4
A _________ provides a high-speed infrastructure to move data between storage devices and file servers.
What is the correct answer?
4
Cisco routers generate LMI enquiries every _______ seconds and a full status update every _________ seconds.
What is the correct answer?
4
What router command saves the active configuration to NVRAM?
A. copy nvram startup-config
B. copy startup-config running-config
C. copy running-config nvram
D. copy running-config startup-config
What is the correct answer?
4
On the 1900 switch, how do you enter User EXEC mode?
A. It comes up by default.
B. Enter the letter U in the menu.
C. Enter the letter K in the menu.
D. Enter the letter C in the menu.
What is the correct answer?
4
When configuring the ip nat inside source command, which parameter must you specify to perform PAT?
What is the correct answer?
4
Extended IP ACLs should be placed as close to the ____________ device as possible.
What is the correct answer?
4
Which is an example of a hybrid protocol?
What is the correct answer?
4
Which types of memory do not maintain their contents during a power-off state?
What is the correct answer?
4
How many steps do LCP and NCP go through when setting up a connection?
What is the correct answer?
4
The TCP/IP protocol stack has ________ layers.
What is the correct answer?
4
Which of the following is true concerning full-duplexing?
A. It can either send or receive frames, but not both simultaneously.
B. It can be used with hubs.
C. It can be used with 10Base5 cabling.
D. It uses point-to-point connections.
What is the correct answer?
4
Which interface type is used to connect to the serial interface of a router?
What is the correct answer?
4
A routing protocol that supports route summarization must perform all except which of the following?
A. Carry the subnet mask with the network entry.
B. Make routing decisions based on the entire destination IP address.
C. Summarize entries so that the same lowest-order bits match.
What is the correct answer?
4
Which of the following is not true concerning TCP?
A. Provides for reliable connections
B. Uses windowing for flow control
C. Multiplexes applications
D. Is more efficient than UDP
What is the correct answer?
4
Annex A is which LMI standard?
What is the correct answer?
4
A _________ is a network that provides a secure connection from a company to other business partners.
What is the correct answer?
4
___________ has both physical and logical ring topologies.
What is the correct answer?
4
Which 2950 command assigns a VLAN to an interface?
A. vlan-membership static
C. switchport access vlan
D. switchport mode access
What is the correct answer?
4
You are given a Class C network with a subnet mask of 255.255.255.248. How many host addresses are there on each subnet?
What is the correct answer?
4
If you see a VC with an inactive status, this indicates ____________.
A. The connection between both Frame Relay DTEs is up and operational.
B. The connection between your Frame Relay DTE and DCE is up and operational, but there is something wrong with connection between your connected Frame Relay switch and the destination DTE.
C. You are not receiving any LMI messages from the Frame Relay switch.
What is the correct answer?
4
When a carrier experiences congestion, it marks the _______ bit in the header of the Frame Relay frame.
What is the correct answer?
4
A _________ looks at OSI Reference Model layers 4-7 to make intelligent decisions about how to obtain information for a user.
What is the correct answer?
4
Which router command would take you back to a suspended telnet session?
What is the correct answer?
4
You have ISL trunks in your network and five VLANs configured. How many instances of STP are running?
What is the correct answer?
4
A _________ is used to connect networking devices that are in a very close geographic area, such as a floor of a building, a building itself, or a campus environment.
What is the correct answer?
4
When using debug with PAP, which of the following message types might you see?
What is the correct answer?
4
Private addressing is defined in RFC ______.
What is the correct answer?
4
Which controller command specifies how ones and zeros are represented on a digital circuit?
What is the correct answer?
4
What would you use to prevent a packet from traveling around a routing loop forever?
What is the correct answer?
4
Which of the following is not an advantage of DHCP?
A. It allows for the use of private addressing.
B. It reduces the amount of configuration on devices.
C. It reduces likelihood of configuration errors.
D. It gives you more control by centralizing IP addressing information.