Home

When choosing a dynamic routing protocol, which of the following should not be considered?

A. Metrics used

B. How routing information is shared

C. How routing information is processed

D. Number of PCs in the network

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. What subnet mask would you use to set up a default route?
  2. Which type of traffic is sent to a group of devices?
  3. A __________ route is the best path to reach a destination within the topology table.
  4. Which of the following is a disadvantage of SANs?
  5. With a rollover cable, pin 7 on one end is mapped to pin ________ on the other end.
  6. A 1924 has _________ Ethernet interfaces.
  7. You are given a class C network and you have four LAN segments with the following numbers of devices:…
  8. A ___________ is basically all of the components, hardware and software, involvedin connecting computers…
  9. You have a total of five routers. ________ circuits are required to fully mesh the network, where every…
  10. IGRP generates an update every ___________ seconds.
  11. Which IGRP command allows unequal-cost load balancing?
  12. Which router command creates a standard named ACL called test?
  13. The 1900 switch supports ________ VLANs.
  14. The default encapsulation on a synchronous serial interface is _________.
  15. You are at User EXEC mode and type the letter e. What message appears?
  16. Which is an example of a hybrid protocol?
  17. A ___________ is similar to a telephone circuit-switched connection.
  18. When setting up an RJ-45 console connection, you need a RJ-45-to-DB-9 __________ adapter to attach to…
  19. You are given a Class C network with a subnet mask of 255.255.255.248. How many host addresses are there…
  20. Which of the following is not an advantage of DHCP?
  21. RIP supports load balancing for up to __________ ___________ paths.
  22. Which VTP mode(s) will propagate VTP messages?
  23. Annex A is which LMI standard?
  24. A _________ routes between different autonomous systems.
  25. If the 1900 SYSTEM LED is _________, a system POST test has failed.
  26. If the 2950's RPS is ________, the external power supply is supplying power.
  27. Which command activates an IP ACL on a router's interface?
  28. The ___________ is the point where the carrier's responsibility ends and yours begins.
  29. You are given the following addressing information: 192.168.37.192/25. What type of address is this?
  30. Which command is used to define the local addresses that are statically translated to global addresses?