Home

Multistage compression of air as compared to single stage compression offers the advantage of

A. Power saving per unit weight of air delivered

B. Moisture elimination in the inter-stage cooler

C. Increased volumetric efficiency

D. All (A), (B) & (C)

Related Questions

  1. The excess air required for the combustion of pulverised coal is of the order of about __________ percent.
  2. The most prominent single cause of corrosion in boiler-tubes, drums, economisers and steam superheaters…
  3. __________ can replace tungsten in high speed steel.
  4. Which of the following has the highest value of refractive index?
  5. As per the Indian boiler regulation (IBR), the type of joint preferred for the circumferential joint…
  6. Brittleness induced due to the presence of sulphur in steel can be reduced by adding
  7. Neutrons are present in all atoms except that of
  8. Gross national product (GNP) means the total value of __________ in a country.
  9. Stellite is a __________ material.
  10. The size of the tetrahedral void in the closest packing of atoms is __________ that of the octahedral…
  11. A spring material should have low
  12. Wavelength of radiation emitted by a body depends on the __________ of its surface.
  13. In the X-ray radiography technique, the tube voltage for thicker plates as compared to thin plates,…
  14. Primary designation of steel is based on its
  15. Particle nature of cathode rays is proved due to the fact that they
  16. If a solid is compressed adiabatically in its elastic range, its __________ remains constant
  17. Load cells used for the measurement of weight has
  18. Which of the following is not a principal alloying element for the structural steel?
  19. To improve the machinability of steel, it is generally subjected to
  20. Alumina, silica, lime and iron oxide are the basic raw material for the manufacture of Portland cement.…
  21. In the formation of cermets, the ratio of ceramic material to metallic material is usually 80:20. Which…
  22. Cascade control is
  23. In __________ process, there is an increase in entropy with no degradation of energy.
  24. Diffusion co-efficient of a metal in a solid solution depends upon its
  25. The most important requirement for aluminium industry is the availability of cheap
  26. The minimum carbon content in steel should be __________ percent for it to respond to a hardening treatment.
  27. Maximum heat dissipation occurs from a steel wire (k = 0.5 W/m. k) of 15 mm diameter exposed to air…
  28. Surface tension of a liquid
  29. __________ remains constant during the adiabatic cooling of moist air.
  30. All of the following alloying elements of steel increases hardness but sacrifice ductility, except

Please do not use chat terms. Example: avoid using "grt" instead of "great".