What command activates the IP routing process?
router
enable
network
no shutdown
Correct Answer :
C. network
Related Questions
Which command assigns a default gateway to the 2950 switch?
(config)# default-gateway
(config-if)# default-gateway
(config-if)# ip default-gateway
(config)# ip default-gateway
A ___________ is basically all of the components, hardware and software, involved
in connecting computers across small and large distances.
LAN
WAN
Network
SAN
Which is not one of the three main functions of a layer-2 device?
Learning
Forwarding
Listening
Removing loops
The ___________ is the point where the carrier's responsibility ends and yours begins.
Local loop
Demarcation point
CPE
Toll network
A 1924 has _________ Ethernet interfaces.
24
26
27
28
How would you suspend a telnet session?
CTRL-SHIFT-X 6
CTRL-SHIFT-6 X
CTRL-6 X
CTRL-C
You are given a class C network, 192.168.1.0/24. You need three networks with 60 hosts and two networks with 30 hosts. What are the subnet mask values you could use?
255.255.255.128 and 255.255.255.192
255.255.255.224 and 255.255.255.240
255.255.255.192 and 255.255.255.224
None of these
If you enter a command in either User EXEC mode or Privilege EXEC mode that the IOS does not recognize, the switch or router
Logs you out
Tries to resolve the command to an IP address
Executes the closest command that it can find in its command set
Makes a "beep" sound
Which router-on-a-stick command defines the VLAN for the interface?
vlan
encapsulation
trunk
frame-type
Which type of traffic is sent to a group of devices?
Multicast
Unicast
Broadcast
Groupcast
What router command saves the active configuration to NVRAM?
copy nvram startup-config
copy startup-config running-config
copy running-config nvram
copy running-config startup-config
Which of the following is false concerning CHAP?
It sends an encrypted password.
It sends a challenge.
It is more secure than PAP.
It uses a three-way handshake.
172.16.240.256 is a class __________ address.
A
B
C
None of the above
You are given a Class C network with a subnet mask of 255.255.255.248. How many host addresses are there on each subnet?
4
6
8
14
A _________ is a network that provides a secure connection from a company to other business partners.
Intranet
Extranet
Internet
_________ negotiates the data link and network layer protocols that will traverse a PPP connection.
LCP
NCP
CDP
PAP
Which of the following is a Network layer protocol for the TCP/IP protocol stack?
TCP
UDP
ICMP
None of these
When configuring a router-on-a-stick, the configuration is done on __________.
Physical interfaces
Major subinterfaces
Subinterfaces
RIP has a maximum hop count of ____________ hops.
10
15
16
100
Which prompt indicates that you are at User EXEC mode?
>
#
%
@
You are given a Class B network with a subnet mask of 255.255.255.192. How many host
addresses are there on each subnet?
30
62
126
254
The _________ reference point defines the connection between the NT2 and the NT1.
P
Q
R
T
Which control sequence moves the cursor to the end of the line?
CTRL-A
ctrl-p
ctrl-e
ctrl-z
Which type of traffic is not flooded?
Multicast
Known unicast
Broadcast
Unknown unicast
__________ allows you to distribute connection requests destined to a single IP address to multiple machines.
Traffic load
Traffic configuration
PAT
Load distribution
An idle DDR connection will be torn down after _________ seconds of not seeing interesting traffic.
120
122
130
132
What subnet mask would you use to set up a default route?
0.0.0.0
255.255.255.255
Depends on the type of network number
None of these answers
RIP supports load balancing for up to __________ ___________ paths.
Six, unequal-cost
Four, unequal-cost
Four, equal-cost
Six, equal-cost
The ___________ converts an ISDN four-wire connection to a two-wire connection.
NT5
NP1
NT1
TN1
OSPF hellos are sent every __________ seconds on a multi-access medium.
5
10
15
40