Related Questions
What is the correct answer?
4
A _________ is used to connect networking devices that are in a very close geographic area, such as a floor of a building, a building itself, or a campus environment.
What is the correct answer?
4
When configuring the ip nat inside source command, which parameter must you specify to perform PAT?
What is the correct answer?
4
Which of the following is false concerning OSPF?
A. It provides a loop-free topology.
B. It is a classful protocol and allows for a hierarchical design.
C. It requires more memory and processing cycles than distance vector protocols.
D. It is complex to configure and difficult to troubleshoot.
What is the correct answer?
4
___________ has both physical and logical ring topologies.
What is the correct answer?
4
Which of the following is false concerning VLANs?
A. A VLAN is a broadcast domain.
B. A VLAN is a logical group of users.
C. A VLAN is location-dependent.
What is the correct answer?
4
Enter the wildcard mask value to match on every bit position in an address: _________.
What is the correct answer?
4
What would you use to prevent a packet from traveling around a routing loop forever?
What is the correct answer?
4
Which of the following are classless protocols?
What is the correct answer?
4
When a carrier experiences congestion, it marks the _______ bit in the header of the Frame Relay frame.
What is the correct answer?
4
_________ defines how the Frame Relay DTE and DCE interact with each other.
What is the correct answer?
4
A routing protocol will use a _________ to determine which path is the best path.
A. Administrative distance
What is the correct answer?
4
_________ has a physical star topology but a logical ring topology.
What is the correct answer?
4
Which command activates an IP ACL on a router's interface?
What is the correct answer?
4
Which interface type is used to connect to the serial interface of a router?
What is the correct answer?
4
The _______ program goes out and finds the IOS and loads it.
What is the correct answer?
4
Which of the following is stored in ROM? (Choose all correct answers.)
What is the correct answer?
4
Which of the following is the most expensive type of WAN connection?
A. Dedicated circuit connection
B. Circuit-switched connection
C. Packet-switched connection
What is the correct answer?
4
How many steps do LCP and NCP go through when setting up a connection?
What is the correct answer?
4
Which command assigns a default gateway to the 2950 switch?
A. (config)# default-gateway
B. (config-if)# default-gateway
C. (config-if)# ip default-gateway
D. (config)# ip default-gateway
What is the correct answer?
4
You are given a Class B network with a subnet mask of 255.255.255.192. How many host
addresses are there on each subnet?
What is the correct answer?
4
What command assigns a User EXEC password to a 2950 switch?
What is the correct answer?
4
You are given the following addressing information: 10.0.8.0/22. What type of address is this?
What is the correct answer?
4
Frames sent above the __________ limit will have their _________ bit set.
What is the correct answer?
4
A _________ looks at OSI Reference Model layers 4-7 to make intelligent decisions about how to obtain information for a user.
What is the correct answer?
4
___________ only translates one (and only one) IP address to another.
What is the correct answer?
4
When backing up your IOS image from flash, which of the following will the copy flash tftp command prompt you for? (Choose all correct answers.)
A. TFTP server IP address
What is the correct answer?
4
_________ allows you to create this summarization: 10.0.0.0/7.
What is the correct answer?
4
Which type of routing protocol uses the Shortest Path First algorithm?
What is the correct answer?
4
A VTP server switch generates a summary advertisement every _________ minutes.
What is the correct answer?
4
On the 1900 switch, how do you enter User EXEC mode?
A. It comes up by default.
B. Enter the letter U in the menu.
C. Enter the letter K in the menu.
D. Enter the letter C in the menu.