Home

Distance vector protocols use ___________ to disseminate routing information.

A. Unicast

B. Multicast

C. Broadcast

Please do not use chat terms. Example: avoid using "grt" instead of "great".

You can do it
  1. How many steps do LCP and NCP go through when setting up a connection?
  2. The function of the MODE button is to __________.
  3. To recall a previous command, which of the following would you use?
  4. Distance vector protocols use ___________ to disseminate routing information.
  5. EIGRP uses the _________ algorithm to update its routing table.
  6. EIGRP generates hellos every _________ seconds on LAN segments.
  7. When examining the IP routing table, an EIGRP route will be shown as what letter?
  8. A 1924 has _________ Ethernet interfaces.
  9. Which router command specifies the ISDN switch the router is connected to?
  10. OSPF supports a ________-layer hierarchical design.
  11. Which metric components, by default, are used in IGRP? (Choose all the correct answers.)
  12. An _____________ is a public IP address associated with an inside device.
  13. OSPF uses __________ as a metric.
  14. What must you do to enable IP routing on your router? (Choose all of the correct answers.)
  15. When using the show interfaces command, which Frame Relay information can you not see?
  16. Which of the following is a valid subnet mask value?
  17. You are given a MAC address of 01A2.0482.FE12. What is the OUI value in binary?
  18. If you see a VC with an inactive status, this indicates ____________.
  19. EIGRP will route for ___________.
  20. An idle DDR connection will be torn down after _________ seconds of not seeing interesting traffic.
  21. Which of the following is the most expensive type of WAN connection?
  22. The switch port that is chosen to forward traffic for a segment is called a __________.
  23. VLSM allows a network segment to have more than one subnet mask.
  24. What router command saves the active configuration to NVRAM?
  25. Which prompt indicates that you are at User EXEC mode?
  26. The slot number of a 1900's Fast Ethernet uplink ports is ________.
  27. What would you use to prevent a packet from traveling around a routing loop forever?
  28. What command assigns a User EXEC password to a 2950 switch?
  29. RIP has a hold-down period of ____________ seconds.
  30. Which of the following is a private address?