Home

In these drawings it is necessary to show cut surfaces and distinguish between adjacent parts:

A. Auxiliary drawings

B. Assembly sections

C. 3D assemblies

D. Parts lists

Related Questions

  1. When setting up a mechanical drawing in Auto-CAD the drafter should set the units to ________.
  2. A partial auxiliary view is used to show only the ________ in the auxiliary view.
  3. Once a drawing is determined to be complete, the title block is used to document the change from:
  4. The most common geometric form used in gears today is this:
  5. This material is used in masonry construction, most commonly for ornamental facing:
  6. A line with a tapering width can be easily created by using the __________ tool.
  7. This is used to indicate that a surface is to be machined:
  8. In order to create an isometric circle to represent a hole through the top surface of a box, the drafter…
  9. When creating your own blocks it is important to avoid drawing any portion of the block in the ________…
  10. A projection weld is a type of:
  11. PDM is the acronym for:
  12. This is a conical-shaped recess around a hole, often used to receive a tapered screw head:
  13. Isometric drawings are often used by ________ to help illustrate complex designs.
  14. When lettering a CAD drawing, for clarity you should limit the number of fonts to:
  15. This type of surface may be a plane, a single curved surface, or a warped surface:
  16. Acceptable parts must not extend beyond this:
  17. In this type of projection, each of the axes has different ratios of foreshortening:
  18. Most architectural firms and mechanical design companies utilize different categories of blocks. These…
  19. The first step in creating a traditional technical drawing is to ________.
  20. Using the Relative Polar Coordinate System to add a 3 inch line that is 45 degrees from the end point…
  21. This practice considers an individual part's dimensions and tolerances and that part's relation to its…
  22. How can the drafter prevent Auto-CAD from placing or stacking another center mark on a circle when adding…
  23. In an assembly section, these parts should have their section lines left out or shown solid black:
  24. The site plan illustrates ________.
  25. A drafter who develops technical drawings of a highway overpass would most likely be a ________ drafter.
  26. The edges of a cube in isometric projection make angles of this many degrees with each other:
  27. A round is a rounded surface on the ________ corner of a part.
  28. On typical electronic diagrams, these items need not be shown unless they are needed for clarification:
  29. This type of projection is when projectors are parallel to each other, but is at an angle other than…
  30. These types of projectors converge at a vanishing point:

Please do not use chat terms. Example: avoid using "grt" instead of "great".