A partial auxiliary view is used to show only the ________ in the auxiliary view.
Projected inclined plane
The projected top view
The projected side view
None of the above
Also checkout these categories
Reproductive System MCQ Ratio and Proportion MCQ Rearrangement Set 7 MCQ Choosing the correct sentence MCQ Automobile Engineering MCQ Biology and Human Welfare MCQ Statutory Deductions MCQ Digestive System MCQ Thermo Electricity MCQ Viruses MCQ Engineering Materials MCQ Morphology of flowering plants MCQ
- An oil refinery relies on which type of drafter to maintain and update the technical piping drawings…
- The maximum and minimum sizes of a feature are identified by a ________ tolerance.
- These drawings are given to contractors to perform work or manufacture individual parts:
- The most common geometric form used in gears today is this:
- Two-point perspective is also known as:
- 3.When lines intersect on a drawing at angles of this many degrees, it is customary not to dimension…
- This is the term for the range of tightness or looseness resulting from the allowances and tolerances…
- Three dimensional models are often used in the design process to __________.
- The principle views associated with orthographic projection are ________.
- This type of drawing is created to calculate areas, locate property lines, and locate building projects…
- Isometric drawings are often used by ________ to help illustrate complex designs.
- These are vertical distances above a common datum, reference plane, or point:
- The Press-Pull tool will ________ the face of a solid model in the direction it faces.
- This type of axonometric drawing has equal foreshortening along two axis directions and a different…
- This is formed where three or more surfaces intersect:
- In this type of auxiliary view, a break line is used to indicate the imaginary break in the views:
- This type of solid is egg-shaped and can be created by revolving an ellipse around one of its axes:
- The View toolbar will position the view of the 3-D solid toward the ________.
- To insure that everyone understands what the electrical symbols represent it is customary to include…
- This is an angled surface used on cylinders to make them easier to handle:
- In multi-view drawing it is common practice to include three views, the front, the top and the right…
- On a floor plan the dashed line that appears approximately 24 outside the exterior wall represents the…
- The ________ tool on the Dimension tool bar places the length of an arch on a drawing.
- How can the drafter prevent Auto-CAD from placing or stacking another center mark on a circle when adding…
- This is a rounded exterior blend between surfaces:
- The Conceptual Visual Style tool is located on the ________ toolbar.
- Drawings created with commercial software are typically saved as:
- The title block used on working drawings should include the __________.
- The building construction industry relies on sets of ________ drawings to construct homes and commercial…
- An engineer's scale would be used to measure lines on a drawing where the scale factor reads ________.