Related Questions
What is the correct answer?
4
You are given the following addressing information: 10.0.8.0/22. What type of address is this?
What is the correct answer?
4
A ___________ is similar to a telephone circuit-switched connection.
What is the correct answer?
4
A Class A address has _________ host bits.
What is the correct answer?
4
EIGRP generates hellos every _________ seconds on LAN segments.
What is the correct answer?
4
A routing protocol that supports route summarization must perform all except which of the following?
A. Carry the subnet mask with the network entry.
B. Make routing decisions based on the entire destination IP address.
C. Summarize entries so that the same lowest-order bits match.
What is the correct answer?
4
The ___________ is the point where the carrier's responsibility ends and yours begins.
What is the correct answer?
4
_________ defines how the Frame Relay DTE and DCE interact with each other.
What is the correct answer?
4
Which router command specifies the ISDN switch the router is connected to?
What is the correct answer?
4
_________ allows you to create this summarization: 10.0.0.0/7.
What is the correct answer?
4
When backing up your IOS image from flash, which of the following will the copy flash tftp command prompt you for? (Choose all correct answers.)
A. TFTP server IP address
What is the correct answer?
4
A _________ is used to connect networking devices that are in a very close geographic area, such as a floor of a building, a building itself, or a campus environment.
What is the correct answer?
4
Which type of routing protocol uses the Shortest Path First algorithm?
What is the correct answer?
4
A routing protocol will use a _________ to determine which path is the best path.
A. Administrative distance
What is the correct answer?
4
Which of the following is a disadvantage of SANs?
What is the correct answer?
4
If the port status LED on a 2950 is ________, there is a physical layer connection problem.
A. Flashing green and amber
What is the correct answer?
4
A _________ provides a high-speed infrastructure to move data between storage devices and file servers.
What is the correct answer?
4
The slot number of a 1900's Fast Ethernet uplink ports is ________.
D. No slot number is used
What is the correct answer?
4
If you wanted a list of parameters for the show command, you would type ________.
What is the correct answer?
4
Which router command creates a standard named ACL called test?
C. ip access-list standard test
D. access-list standard test
What is the correct answer?
4
__________ states that if a neighboring router sends a route to a router, the receiving router will not propagate this route back to the advertising router on the same interface.
What is the correct answer?
4
You have this binary value: 11000001. This equates to _____ in decimal.
What is the correct answer?
4
Which type of traffic is not flooded?
What is the correct answer?
4
What command assigns a User EXEC password to a 2950 switch?
What is the correct answer?
4
Which of the following is true concerning bridges?
A. They switch frames in hardware.
B. They support half- and full-duplexing.
C. They support one collision domain for the entire bridge.
D. They do only store-and-forward switching.
What is the correct answer?
4
Which of the following commands belongs on the physical interface when using dialer profiles?
What is the correct answer?
4
A ________ topology describes how devices communicate with each other.
What is the correct answer?
4
A _________ looks at OSI Reference Model layers 4-7 to make intelligent decisions about how to obtain information for a user.
What is the correct answer?
4
Which metric components, by default, are used in IGRP? (Choose all the correct answers.)
What is the correct answer?
4
With a rollover cable, pin 7 on one end is mapped to pin ________ on the other end.
What is the correct answer?
4
VLSM allows you to summarize 192.168.2.0/24 and 192.168.3.0/24 as 192.168.2.0/25.